only fat channel/40mhz intolerant clients cause this problem. the network will try to go down to ht20 then drop clients & hang, fat channel/40mhz intolerant is an optional spec & doesnt need to be enforced, the ht40 setting is supposed to be an override to force the network at ht40 so the router should have final say not a random client. "As you can see in the screenshot, the channel 7 overlaps with 5 other channels The UniFi 6 Long-Range is the only device that can offer up to 160Mhz channel width, this should allow it to offer significantly faster speeds than all the other devices 40 MHz and 80 MHz channel width are also supported on some devices 40 MHz and 80 MHz channel. It is often more crowded and less performant than 5 Ghz. In general 2.4 Ghz should be considered a legacy band for older devices that do not support 5 Ghz. As can be seen in the above diagram, these channels do not overlap into each other. When enabled, the client informs access points that it does not support 40 Mhz wide channel-widths in the 2.4 GHz band.What is the best channel for 2.4 Ghz? The recommended channels to use on 2.4 Ghz are Channel 1, 6 & 11. It can control multiple UniFi access points (APs) and mesh extender, such as the Beacon Wider channels are faster but more susceptible to interference, and also more likely to interfere with other devices change to channel 11 7 Mpps MAC Address Table Size 8 K Packet Buffer 750 KB Static Routing Table Size 128 Jumbo Frame Size 9 The UniFi port.Should I enable fat channel intolerant? Unless there is a very specific reason to use it then you should enable, if not just leave it disabled. To disable a feature, un-check the checkbox. To open the Windows Features screen, go to Run –> optionalfeatures (This can also be accessed by opening Start Menu –> Control Panel –> Programs and Features –> Turn Windows features on or off) To enable a feature, check the checkbox beside the component.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |